SERVICE MODE AND POWER SUPPLY CIRCUIT SONY KDL - 40W5500

SONY KDL40W5500



SERVICE MODE AND POWER SUPPLY CIRCUIT

How to enter the Service Mode
Service adjustments to this model can be performed using the supplied Remote Commander RM-ED016.
1. Turn on the power to the TV set and enter into the stand-by mode.
2. Press the following sequence of buttons on the Remote Commander.
ON SCREEN DISPLAY > CH 5 > VOLUME + > POWER ON
3. The TVM menu appears on the screen
Note : After carrying out the service adjustments, to prevent the customer accessing the ‘Service Menu’ switch the TV set OFF and then ON.
Changing TVM Data Settings
1. Press “2 / 5” on the remote commander to select (up / down) category.
2. Press “1 / 4” on the remote commander to select (up / down) item.
3. Press “3 / 6” on the remote commander to select (up / down) data .
Writing TVM Data
1.Press “Mute” on the remote commander. The word “SERVICE” changes to “WRITE”
2.Press “0” on the remote commander. The word “WRITE” changes to red. This indicates writing is in progess.
3. When red “WRITE” changes to green “SERVICE”. This indicates writing is complete.
 SELF DIAGNOSTIC SOFTWARE
The identification of errors within the EX2L chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant device number will be displayed through the LED (Series of flashes which must be counted).

LED Flashes
Error Description
Error (Comp ref)
02
main Power Error
Pwr_Err
05
DC_Alert3
DC_Alt
06
Backlight Error
Bck_Lgt
07
Thermal Error
Thm_Err
08
Audio Error
Aud_Err
10
Digital FE/BE Error
Dig_Err
12
HFr Error (T-Con)
Hfr_Err
13
Balancer Error
Bal_Err
14
T-Con Error
Tcn_Err











To bring up the self diagnostic screen display
In standby mode, press the following buttons on the remote commander sequentially in rapid sucession as shown below:
 ON SCREEN DISPLAY > CH 5 > VOLUME -- > POWER ON
POWER SUPPLY CIRCUIT 
CLICK ON THE IMAGE TO ZOOM IN


3 DIGIT UNIVERSAL REMOTE REMOTE CODES FOR SONY TV

006, 301, 005, 446, 412, 393, 375, 360, 325, 255, 203, 185, 174, 058, 003