SONY KDL-32S5600 - KDL-37S5600 - KDL-40S5600 SERVICE MODE + POWER SUPPLY CIRCUIT

SONY KDL-32S5600 / KDL-37S5600 / KDL-40S5600

BRAVIA SERIES 




SERVICE MODE AND POWER SUPPLY CIRCUIT 


SERVICE MENUS
How to enter the Service Mode
Service adjustments to this model can be performed using the supplied Remote Commander RM-ED017.
1. Turn on the power to the TV set.
2. Press the following sequence of buttons on the Remote Commander.

INFORMATION BUTTON i > 5 >VOLUME + > POWER ON

3. The menu appears on the screen .
4. Move to the corresponding adjustment item using the UP/ DOWN arrow buttons on the Remote Commander.
5. Press the ‘RIGHT ’ arrow button to enter into the required menu item.
6. Adjust the data value using the ‘UP ’ or ‘DOWN ’ arrow buttons on on the Remote Commander.
7. To go back at any time press the ‘LEFT ’ button on the Remote Commander.
8. Ensure you return to the top level menu, and press the Green button on the Remote Commander to Store all the adjustments.
9. Press the Red button or ‘Menu’ button on the Remote Commander to quit the Service Mode when all adjustments have been completed.
After carrying out the service adjustments, to prevent the customer accessing the ‘Service Menu’ switch the TV set OFF and then ON again
Service Menu Structure
The following descriptions show the items that can be viewed and/or adjusted using the Service Menu.
Service General Menu
The menu appears on the screen when you enter the ‘Service General Menu’ (See Pic.2). This menu allows you to view the product information, set the TV into Aging Mode and perform Software Upgrade to the TV set.
White Balance Adjustment
The following menu appears on the screen when you enter the ‘White Balance Adjustment’ menu (See Pic.3). This menu allows adjustment of the TV picture levels. These adjustments are set during manufacture and should not normally require further adjustment.
Factory Reset
Selection of ‘Factory Reset’ allows the TV to be reset to factory shipping condition. This will restore all settings to those which were contained in the TV on first shipment.
TT MODE
The TT modes described below are available by selecting the two relevant digits. You can exit the ‘TT Mode’ by entering 00, by pressing the ‘Analog’ or the ‘Digital’ button, by switching the TV set into Stand-by mode, or by Powering the TV set off.
Note :
To place the Remote Commander in ‘TT Mode’ press the following buttons together for approximately five seconds.
EXTERNAL INPUT > 5 > VOLUME +
To use the Remote Commander in ‘TT Mode’ press the ‘Red’ text button on the Remote Commander twice.
TT will then appear in the bottom right hand corner of the TV.

To take the Remote Commander out of ‘TT Mode’ press the same buttons together for approximately five seconds.

SELF DIAGNOSING 
Number of LED Flashes
Error Description
Checked
Action
02
Balancer error.
In normal and factory mode.
Goes into standby.
03
Power supply protection error.
In normal and factory mode.
Goes into standby.
04
Inverter error.
In normal and factory mode.
Goes into standby.
05
NVM error.
In initialisation state.
Adds error to error menu.
06
IIC error.
In normal and factory mode.
Adds error to error menu.
08
Audio error.
In normal and factory mode.
Adds error to error menu.
09
Tuner error.
In initialisation state.
Adds error to error menu.
18
COFDM error.
In digital mode and initialisation state.
Adds error to error menu.
19
USB error.
In normal and factory mode.
Adds error to error menu.
20
CI error.
In normal and factory mode.
Adds error to error menu.


POWER SUPPLY CIRCUIT 

CLICK ON THE IMAGES TO ZOOM IN